How to Hang a TV on a Brick Wall: A Step-by-Step Guide for a Secure Installation

Mounting a TV on a brick wall is completely feasible with the right preparation and tools. Follow this guide to securely install your TV and enjoy a clean, modern look in your living space.

What Supplies Do You Need for Mounting a TV on a Brick Wall?

1. TV Wall Bracket: Choose one that matches your TV’s size and weight.
2. Power Drill: Preferably cordless with a hammer function; avoid using an impact driver.
3. Masonry Drill Bits: Essential for drilling into brick or concrete.
4. Level: To ensure the TV bracket is aligned properly.
5. Permanent Marker: For marking drill hole locations on the brick.
6. Anchors or Concrete Screws: Plastic wall anchors for smaller TVs, concrete screws for larger TVs.
7. Driver Bit: To tighten the screws or anchors.
8. Washers: If the mounting hardware holes are too large for screws.
9. Tape Measure: To measure the correct placement.
10. Hammer or Rubber Mallet: To install anchors securely.
11. Small Shop Vac: For cleaning up dust from drilling.
12. Safety Gear: Wear safety glasses and a dust mask for protection.

How To Hang a TV on a Brick Wall

Step 1: Choose a Location

• Ensure your chosen location is near an electrical outlet and cable jack to minimize visible cables.

Step 2: Find the Installation Height

• Attach the bracket to the TV per the manufacturer’s instructions.
• Measure the distance from the bottom of the bracket to the TV’s bottom.
• Add this to your desired TV height to find the exact position on the wall.
• Mark the location for the bracket on the wall.

Step 3: Mark the Drill Holes

• Hold the wall bracket against the wall at the correct height.
• Use a level to ensure the bracket is straight.
• Mark the screw hole locations on the brick using a permanent marker.
• Avoid mortar lines, as they are softer than brick and can affect the stability of the anchors.

Step 4: Drill the Holes

• Attach the masonry bit to your power drill and mark it with tape to match the length of your anchors or screws.
• Set the drill to the hammer function (if available) or high speed.
• Begin drilling into the brick, removing dust occasionally with a shop vac until the holes are the correct depth.

Step 5: Install Plastic Anchors (Skip to Step 6 if Using Concrete Screws)

• Use a rubber mallet or hammer to gently tap plastic anchors into the drilled holes.
• If they don’t fit easily, clear out extra dust with a shop vac.

Step 6: Install the Bracket

• Insert screws through the bracket and into the drilled holes.
• Tighten the screws using a drill or ratchet with a socket to secure the bracket.

Step 7: Install the TV

• For two-piece brackets, simply mount the TV to the wall bracket using the included locking screws or tabs (refer to the instructions).
• For one-piece brackets, have a helper hold the TV in place while you screw the bracket into the TV.

Step 8: Clean Up and Enjoy

• Conceal any hanging cables with a furniture piece or cable management solutions.
• Relax and enjoy your newly mounted TV!

With these steps, your TV will be securely mounted and ready to use.